Cruiser Pro T3 Tower Fan(1st. Gen.)

Please check if the indicator of the display is on, ensure that the voltage and frequency is the same as required in the user manual (US: 120V 60Hz) or test with another socket.
Then make sure if the power button on the control panel is abnormal by turning it on via the remote control.

Please re-plug the power adapter.
Then press the power button/remote control to power on.
We recommend you check the air inlet/outlet and see if there are any obstacles and abnormal deformations.

Please send a picture of the temperature on the display.
It is normal if the temperature difference is less than ±3℃/37.4℉.

Please switch the fan speed to a higher one.
Then switch to normal mode.
We recommend you clean the inlet grills and test the tower fan again.

Note: It is 44, 55 and 66db at low, medium and high speed respectively.
The noise level is about 44dB at low speed. The higher the gear setting of the tower fan, the louder the noise will be. We recommend turning down the fan speed to see if the noise will be reduced. Please try the following steps.
If you can, please take a short video and send it to support@dreo.com as soon as possible.
Please relocate the fan.
Then try to apply lubricant to the base if the noise only happens while the fan rotates.

Normally, fan speed reduces from the set speed every half an hour until it reaches low speed, then continues in Sleep mode until turned off manually or via timer. The LED display will automatically turn off after 30 seconds under Sleep mode.

Please test with the remote control.
If you can, please take a short video and send it to support@dreo.com as soon as possible.

Please test by controlling the tower fan via the control panel.
Then replace the battery in the remote as instructions in the User Manual.
Note: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type

Check whether the floor is flat.
Check whether the base of the tower fan is normal. Foreign objects may affect the stability.

Please make sure if it is due to that the timer is on.
Then check if the AUTO icon on the display is on. If it is on and the ambient temperature lower than 23.89℃/75°F, the fan will stop with AUTO symbol flashing on LED Display.

You can turn the screen off by switching the style to sleep mode. It will be turned off in 30 seconds.
In other modes, you can turn off the LED screen when pressing the On/Off button for more than 3 seconds.

Please check if there’s an OSC icon in the lower right corner of the screen to make sure whether the OSC function has been turned on.
Then check if the fan body is stuck or entangled by the cable.